Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Hybrid View

  1. 04-01-2022, 07:37 AM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,154
    Add Roberts_Clif on Thingiverse
    There is many you-tube videos as I started I too was a newbie, using You tube videos.
    I found one piece at a time learning as I built the attached model below.

    If I can do this anyone can..

    New Case Layout.jpg

    Started with a rectangle block, howled out the inside, contoured the corners... ect... ect...
    Until I finally designed this snap together controller case for my 3D Printer using Fusion 360 free for hobbiest.
    Last edited by Roberts_Clif; 04-01-2022 at 07:43 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules