CTC Anet A8? Print not centering on bed. Advice needed.

[Hamish]

Hey Roberts_Cliff,

Thanks for your reply.

I originally attached the 3d printer to my laptop via USB but it was not recognised. I went into device manager and it was showing as an unknown device. I have been unable to find a driver for it.

So i have been printing off a MicroSD card i had lying around.

Ill look more into getting a driver and trying to get my laptop to recognise it.

Is there a tutorial or any documentation for what you are advising.

This is all new to me and im completly uncertain.

Thanks again.

[Roberts_Clif]

I Installed a driver that was listed as good for the USB

I watched Where nerdy is cool video

Driver location here