Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 49

Threaded View

  1. 03-16-2014, 11:10 PM #35
    MeoWorks
    MeoWorks is offline
    Technologist MeoWorks's Avatar
    Join Date
    Oct 2013
    Location
    Sacramento, CA
    Posts
    173
    You're correct, Rob, no supports needed on this guy. I was tempted to print at 0.05mm but decided it was a bit of a waste haha. I usually save 0.05mm for hi res character sculpts. But yes, 0.1mm at 30mm/s, I was being overly cautious due to the corners but it should be able to handle 50mm/s without problems.

    Took a short video earlier, sorry for the dogs barking...

    https://www.facebook.com/photo.php?v...type=2&theater
    Last edited by MeoWorks; 03-16-2014 at 11:15 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules