Results 1 to 6 of 6
Threaded View
-
06-26-2014, 07:23 PM #2
I painted mine before assembly to cover the laser cutter scorch marks.
I printed the top piece of the right hand X-idler assembly which carries the Z-axis end stop switch rod. http://3dprintboard.com/showthread.p...ate-*-stl-file
I've fitted the auto bed leveling assembly
The best mod so far has been to install three strips of LEDs around the base of the extruder assembly so that the print bed is illuminated. http://3dprintboard.com/showthread.p...the-Print-Area
I fitted an auto horn relay in the heatbed circuit so that the heat bed gets the full 12V (Don't try to do the same for the extruder heater or you will fritz your RAMPS board).
I moved the RAMPS board to the top of the printer for easier access to all the connections. Makes the printer look untidy, but what the heck? I can get at evrrything on the board if needs be.
Old Man EmuLast edited by old man emu; 06-26-2014 at 07:25 PM.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion