Quote Originally Posted by DrLuigi View Post
Ye those Vinyl that you get with the Makerfarm kit,

I might try to print one of em, And see how they fit, as even a zip tie is JUST small enough, even when the idler comes to close to the Z motor it will even interupt.
Incidentally... Those are from the Prusa i3 open source. I had a problem where my clamps kept cracking and falling off. So I scaled the clamp to different sizes so I could try different ones and see which ones held and did not break. They clamp down with a M3 cap screw. One of those will probably grab the vinyl just right. Hopefully... They will fit within the tolerances you have.