Results 1 to 10 of 20
Thread: "Cold spot" on my heated bed?
Threaded View
-
06-18-2014, 02:27 AM #10
I did a print today with a 0.2mm first layer and slow speed for the first layer. The print was almost OK, but lifted after about 10 layers. I slopped some slurry under the lifted part and held it down intl it stuck. After that the print was OK.
I think I will increase the bed temperatures and also give it a good heating period before I hit the print button. My thermistor is under the heat bed, so it is not indicating the glass temperature. I think that skipping the heat up period is a sign of too much enthusiasm to get printing
OME
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials