obsurdly long print time for a rather small print

[Roberts_Clif]

Do not know what the actual print speed was but Cura 15.04.6 displays 10.1mm^3 per sec when I Hover over Print Speed.

Layer height .28 - 1st Layer Sprint speed 32 percent though raised it to 40 midway in the 1st Layer remaining layers 90 percent.

Cura Panel.jpg

1st Layer 17 minutes
2nd Layer 8 minutes
3rd Layer 2:44 minutes 50% infill
4th Layer 2:44 minutes 50% infill
5th Layer 2:44 minutes 50% infill
6th Layer 2:44 minutes 50% infill
7th Layer 2:44 minutes 50% infill
8th Layer 2:44 minutes 50% infill
9th Layer 2:44 minutes 50% infill
10th Layer 8 minutes
11th Layer 8 minutes

Time is in the Photo below 1 Hour.
90%.jpg
Panel.jpg