Close



Results 1 to 10 of 16

Thread: ABS Warping

Threaded View

  1. #3
    I have a Cocoon Create which is a copy of something like a Wanhao Duplicator I3. That is printing at 230 degrees but if I go much lower than that it looks like the ABS is not melting properly which is probably right.

    In the attached photo the bottom of the centre one inch wide is all rough in both PLA and ABS. Looks like in this one it has to span a smaller space so does not like printing in mid air. A mate mentioned I need to put supports under that area so it prints properly. Not sure if that is right? (Just noticed Cura does supports so am doing a print with supports now.)I am printing it again with Raft on. I'll see how that goes to stop the lifting.

    Any other comments would be appreciated.



    Taranis Joystick Holder.jpg

    Just trying different temperatures to stop the supports from having gaps.

    FatShark Goggle Supports Broken.JPG
    Last edited by Firepower; 07-19-2018 at 10:09 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •