Just got a 3d Printer - Couple questions

[curious aardvark]

as for which is extruder 0 (usually right as you look at the printer) and which extruder 1 - just check where they are plugged in on the board :-) The sockets are usually labelled.

Or better yet, heat one up and see which gets hot :-)

[Cougar281]

as for which is extruder 0 (usually right as you look at the printer) and which extruder 1 - just check where they are plugged in on the board :-) The sockets are usually labelled.

Or better yet, heat one up and see which gets hot :-)

Well, yes lol. I have them wired up with the right one as 0 and the left as 1 - My reason for asking was more because I'd assume that with regards to printing, which one is on which side does matter (primarily when printing with both, I'd think).