At this point I'm just going to make sure I update this because I can't let this part beat me. I'm mostly messing with infill and speed now.

I changed orientation and watched them print some more. Still hardcore rippling and I guess "blobbing". I slowed it down to half speed for more than half the print just to see and it helped a lot. When I slowed it down it had like 6 good layers and 1 bad one repeating.

Since I can't change acceleration settings in S3D (I wish I could, I don't like messing with my printers firmware) I don't know if I can justify slowing the acceleration down more just for this part because I would continually have to go in and change my firmware back to standard accel settings. I might try it just once to see if it helps even more

hmmm