Originally Posted by
number40Fan
That is the weirdest thing I have seen. But, with the issues I had with mine, I wouldn't put it past the wiring that goes down to the carriage. Mine was rubbing at only certain parts/stretches of the print causing the temp reading to swing all over the place. Look carefully at the top-back screw that has the silver washer on it, that the cables are zip tied too. Check the wiring around it. Cut the zip tie off to relax the wiring and try printing that again.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials