Auto_Bed_Leveling: Enhanced G29 command

[ctcwhexdx]

Good Morning,,

I am running into an issue when I try to follow the first post for setting this up, I downloaded the most recent firmware from the link on the first post, as mine is older, made all the changes according to the first post and when I go to compile this I get the following errors:

Marlin_main.cpp:1943:2: error: #endif without #if
Marlin_main.cpp: In function 'void process_commands()':
Marlin_main.cpp:1937: error: 'dock_sled' was not declared in this scope

Now if I just compile the firmware without any modifications it compiles without any problems.

I am not sure but I think there's been some changes made to the code since this thread was started, has anyone else run into this?

I would appreciate any ideas

Thank You