Auto_Bed_Leveling: Enhanced G29 command

[MarcoM]

Trying out your new code - having the same problem as the std G29 - I have a custom delta with a servo deployed probe. If I run G29 w/switch triggered it moves the head off between towers X & Y) and with switch triggered wants to crash in tower Z. I just can't figure out why it's doing this. Any ideas?

[Roxy]

Trying out your new code - having the same problem as the std G29 - I have a custom delta with a servo deployed probe. If I run G29 w/switch triggered it moves the head off between towers X & Y) and with switch triggered wants to crash in tower Z. I just can't figure out why it's doing this. Any ideas?

So I don't know for sure... But in the non-Delta printers there is a case where the nozzle doesn't retract and drags along the bed to go to where it needs to be. There is another thread in this section that RegPye started where we manually fixed the problem with several lines of code. It is a long thread, but how about we do this. How about you review that thread, and then start a new thread detailing your problem (maybe with a short video???) and with some back and forth, we can work through it.