Results 1 to 10 of 15
Thread: What is causing this?
Hybrid View
-
06-18-2017, 12:27 PM #1
What are we looking at here? Where did this come from? When did it happen?
-
06-18-2017, 12:57 PM #2
- Join Date
- Jun 2017
- Posts
- 9
-
06-19-2017, 02:03 PM #3
- Join Date
- Jun 2017
- Posts
- 9
I experienced what I assume is the same thing again. This time I was not able to pull it out. I took apart the extruder and that is not the issue, it was completely clean. The jam persists somewhere between nozzle and in the tube.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion