Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 18

Hybrid View

  1. 06-18-2017, 07:29 AM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Purchased two 3D-Printers that the original owners were unable to fix, Went thru this Chinese nightmare twice. 1st Printer was even missing assembly instructions, CD and Tools. If it was not for YouTube HackaweekTV Video's would have never assembled the 3D Printer. Thank you Hackaweek and Youtube! Now have two Working 3D Hictop Printers.

    Don't quit, You currently know what is wrong with the printer. You have basically already fixed it, you found the broken steppers.
    Most people couldn't have accomplished that. Replace the two steppers, you have won the war then decide after your 1st print.
    Last edited by Roberts_Clif; 06-18-2017 at 08:21 AM.
    Reply With Quote Reply With Quote
  2. 06-18-2017, 11:23 AM #2
    jeffmorris
    jeffmorris is offline
    Engineer-in-Training
    Join Date
    Jan 2016
    Posts
    326
    The cables between stepper motors and the board may be bad.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules