I wanted to say thank you again for your help with this first off. I ended up doing a 1 perimeter cube 20x20, setting the multiplier to 1 and the width to .4mm as suggested on 3dhubs. The thickness of my walls were on average .48 so I ended up with a suggested new multiplier of .9. Just as you had suggested! But when I do this I notice my perimeter layers are not completely filled in. As in my top layers usually have holes instead of being totally solid. This is after measuring the filament and inputting those values. Would the layer height affect this? Should I bump up to .95? Also I've been experimenting with temps and I don't see a real difference between 180 and 200. Should I stay low or run hot? I've heard running as cold as possible is best but I definitely don't want to extrude so cold I am putting unnecessary wear on the extrduer stepper.