Results 1 to 7 of 7
Threaded View
-
01-18-2017, 09:00 PM #1
- Join Date
- Nov 2016
- Posts
- 20
Test cube help - walls slightly tall
Looking for a little help. My qidi tech I is doing good, after some learning I thought I would dial in the calibration a bit. Printed a 20x20x10mm tall cube with 3mm layers single wall. Increased extrusion multiplier to .95 in s3d which closed up some gaps on the bottom layer.
The walls are slightly taller than the body center. Same the the edges on the side, they slightly protrude. The top is flat, just the walls protruding.
Any suggestions?
Thanks!
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials