Resetting my printer

[noiseboy72]

Did you update the firmware on the printer, or just use a different slicing program? If you updated the firmware, it sounds like you have the wrong type for the printer. Have a look at the Sailfish info sticky about this.

TBH, you are normally better just printing off SD card rather than by USB. What happens if you fire up the printer without an SD card or USB connected?

[Exodux1]

Noisyboy72, I did update the firmware on the printer (RepG). Im using Mac OS if that makes any difference. Been trying all sorts of things to bring this printer back to the factory settings. I agree with using a SD card, but the problem I was having( using Autodesk Fusion 360) was, it has no option for a dual extruder and the prints were coming out about 5% smaller. Im totally new to 3D printing, but not to designing on cad.
Thanks for response!

[FarrajSalihDeeb]

Noisyboy72, I did update the firmware on the printer (RepG). Im using Mac OS if that makes any difference. Been trying all sorts of things to bring this printer back to the factory settings. I agree with using a SD card, but the problem I was having( using Autodesk Fusion 360) was, it has no option for a dual extruder and the prints were coming out about 5% smaller. Im totally new to 3D printing, but not to designing on cad.Thanks for response!

I have a Mac OS too, it doesn't matter.