I have a HICTOP prusa i3 3dp-12. Aluminium and auto level heated bed. https://www.amazon.co.uk/gp/product/...?ie=UTF8&psc=1

It was working perfectly when built on saturday. did a large print on sunday (green pen holder) and was working fine. then hasnt been used until today.

For some reason today, every print I've tried has failed. The head and bed keep randomly moving to the endstops and the extruder reversing the filament out??

I dont know what I've done to it. I did some cable management yesterday when I had a minute but other than that I dont think anythings changed.

Ive tried gcode from my desktop pc cura and my laptops both resulting in the same thing. Ive reset to default profile and its the same.

See attached video and photos.
- shows it backing the filament out after going to the endstops.

It was doing the same with the green filament this morning, hence changing to the black to try but obviously no difference.

When it was working fine -
20161102_135152.jpg20161102_135203.jpg

Now -



Thanks
Richard