Extruder not moving in Marlin

[Roxy]

So that confirmed what i was expecting. There was something wrong with that specific version or the way i configured it because the bugfix version worked flawlessly.

And if there are any strange things, there is lots of debug code that can be turned on to display what the machine is seeing throughout various operations. That is very valuable when strange things happen during homing, probing, or bed leveling.

[printbus]

Roxy -

I'm wondering about another possibility. Reject it if you disagree. Could there be an issue with the feedrate/acceleration terms for the extruder being way too high? If I recall, Marlin has a set of different feed rates for manual LCD actions vs the upper limit on gcode control. Maybe the 1mm from the LCD is really just a blip of movement obtained before the motor step rate gets too high, and from gcode the step rate is just too high to begin with and nothing happens at all.

[iineviitable]

I thought of that aswell but i turned the acceleration down to less than 1000 and it didn't seem to help, i may have done it wrong though.

[Windflily]

I am not quite sure about it. Stick RPG 2