Results 1 to 8 of 8
Thread: Submarine Not Watertight
Hybrid View
-
09-30-2016, 10:10 PM #1
It would also help to post the .STL file. But what is happening to you is similar to what happens to me if I don't pick enough solid top layers. It kind of looks like what happens when you have very sparse (10%???) infill and then try to put a top layer on it. It takes a few layers before you have enough to build on to get a polished top layer. I'm overly conservative on that, but I usually have 10 solid top layers just to make sure I don't get to the end of the print and have it fail because the printer can't quite bridge the gaps and close up the infill.
-
09-30-2016, 10:30 PM #2
- Join Date
- Jan 2016
- Location
- Charleston SC
- Posts
- 16
Thank Roxy! How do I set that up on Simplify 3D?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion