Pegasus 12" Build Notes

[uncle_bob]

Hi

Here are a few of the printer plugged in with the LED lamp running. It's also a great shot of all the junk ...

226_ - 1.jpg


Above is a front view that gives a pretty good idea of how the 10W LED lamp lights up the printer. The edge of the printed mount is visible in the next picture. It also gives an idea of just how much shimming I needed to do to get things close to level on a folding plastic table.

226_ - 2.jpg

Another view of the front of the machine from a different angle.

226_ - 3.jpg

The one above shows the heated bed solid state relay at the lower left and the LED light at the upper right. It also shows how the cables run along the top side of the machine.


226_ - 4.jpg

This one is a pretty good view of the dual power supplies and how the newer / cheaper Meanwell supplies fit on the machine. I have two simply to give *lots* of power to the heated bed.

Hopefully that should give people a pretty good idea of what mine now looks like.

Bob