Great news gentlemen! - this adjustment screw is now on the back (my machine a few weeks old)

which makes it much easier to get to - NOT!



which means you get to do something like this



my notes -

The fan screws hold the stepper motors on.

I think it would have been easier had i unloaded the filament first.

you can put the fan screws into the mounting holes on the bottom of the plate, and mine were spot on the same length - if only i had something the right height to check it against... i did think about printing one... and then was like.. oh yeah.. pieces..

It's hard to measure with calipers - as there are no good parallel surfaces to the nozzles - but i think i did ok.