Qidi Tech 1 Simplify 3D Startup Script

[KludgeGuru]

I just updated the scripts to change the default VRefs to 80 instead of 127.

Changed this line:

G130 X127 Y127 Z40 A127 B127 ; Default stepper Vrefs

To This:

G130 X80 Y80 Z40 A80 B80 ; Default stepper Vrefs

Feel free to experiment with the values. Recommended values are between 60-80. By lowering these values you decrease the power to the stepper motor which helps with heat and may make your steppers last longer. If you lower the values too low the steppers will start to skip. For more info see discussion starting here:
http://3dprintboard.com/showthread.p...ll=1#post88762

Alternatively you could change the VREFs in the EEPROM using Replicator G and remove the lines from the scripts altogether.