Results 1 to 3 of 3
Thread: Odd print behavior
-
03-31-2016, 04:52 PM #1
- Join Date
- Oct 2014
- Posts
- 134
Odd print behavior
I am at a loss to figure this out. I use ABL, verified that the Z offset is correct. Nothing has changed in S3D settings, same roll of filament as my last successful print.
DSC_0001.jpg
-
03-31-2016, 08:20 PM #2
It does look like you are a little bit too far off of the bed. And you may need more hair spray in the middle.
-
04-01-2016, 08:20 PM #3
- Join Date
- Oct 2014
- Posts
- 134
Please explain to me how to...
05-13-2024, 03:08 PM in 3D Printer Parts, Filament & Materials