Results 1 to 8 of 8
Threaded View
-
03-24-2016, 02:38 AM #4
- Join Date
- May 2014
- Posts
- 67
Yea I understand some may need that extra space on the print bed... me, I never had it to begin with so it's not that big of a deal. I find that with a 5-6mm glass bed, and longer extruder tubes, the bed springs are more compressed which helps keep the bed level and less "bounce" or less prone to losing position.
I have a spring load extruder on the left side, but as I mentioned in the post, unfortunately it has slightly tighter tolerances in the space between the nozzle and the extruder block.. slightly moreso than the default extruder block on the right-hand side, so I have uneven extruder tubes (I have to slide the right one down further to make up for this).
I'm contemplating going back to both original extruder blocks on mine, since I think I have some filament leak during printing out the back-end of my nozzle.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials