Results 1 to 10 of 96
Thread: Anyone used Printbite surface ?
Hybrid View
-
09-09-2016, 07:12 PM #1Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
-
09-10-2016, 12:39 PM #2
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
-
09-10-2016, 03:14 PM #3
Nice!!
I have made the center plug under the bed, the door clip and I am making the other interior caps today.
I have not gotten to the parts bin, I just finished a mount system for my RPi3 and Pi Cam and mounted them up a few mins ago. I had my OctoPi system hanging all over the place now it is nice and neat, just have to make ribbon cable clips and all will be good. I will upload pics later.
Editor in Chief
Bitsonline
Tips Appreciated But Not Expected
BTC: 16wxHvKd3oU6SVjv6FrenqhkvRmc8t7sPy
DASH: XqyaWxH896j9YeV1M35Gzb5gmRPmPbNDGq
-
09-10-2016, 04:44 PM #4
- Join Date
- May 2016
- Location
- Annapolis, MD
- Posts
- 523
This one is not by cncartist, but is an exceptionally useful hinge for the QiDi's front door. http://www.thingiverse.com/thing:1697406 If you slide it to the right it locks the door up in the open position, rotate down by 30 degrees and you can lift to remove the entire door. Kind of made the door clip unnecessary though.
-
09-10-2016, 11:21 PM #5
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials