Hi Everyone,

Completely new to the 3D printer world, I have purchased the Prusa I3 and it has arrived today. Got it all built/ connected up and it seems to be functioning electrically/mechanically. Now I have setup all limit switches and using Pronterface have set it all up. But I followed a youtube vid and it shows you to print a 20mm cube off. Well... Must of tryed 15/20 times now and it wont stick to glass at all. Have tryed some hair spray as seen online and have tryed printing onto paper. The paper was the most successful but still terrible. It just seems to start laying down then gets all clogged around nozzle and just makes a mess. Please could someone tell me there reccommended settings to be setup in Slic3r and see if I can get something made Also how far should I have the nozzle set off the glass as cannot find a figure in the manual at all.

Many thanks in advance

Adam