Technical specifications of 3d printed ABS

[frank12444]

Well i done a pull test with a piece of 100 procent infill ABS,
It was 10mm width and 5thick i believe.

It was around 250 newton to get it sepperated and 3.2mm stretched out.
I forgot to look on how much it needed on its highest strength, But that was somewhat the number ive seen throughout the stretching process.

Done the same for PLA it was also around the 200 i believe, thats like a month ago so i aint fully sure ^^
Also those sticks where made when my printer didnt extrude enough plastic, So probably it would have had more strength if i redid it, PLA stretched back then 2.9mm.

Thanks for these number!
Now do you remember how long the pieces where before stretching, that would help even more go get a general idee compared to molded ABS.