CTC printer settings

[EagleSeven]

Hi, Can someone please tell me what the factory offset settings are for my printer when it is first set up ?
I upgraded to sailfish and forgot to write them down.
Now my printer hits the left side and clicks a few times after it prints the purge line across the front at the start of print. I have noticed it doesn't always do this, but most of the time it does.

I don't remember any Offset settings in Firmware, Only in slicer software.

I think these are the settings needed ?
(if not, let me know, and I will look further)

"bedZOffset": 0.0,
"startX": -110.4,
"startY": -74.0,
"startZ": 0.2,