Results 1 to 10 of 34
Threaded View
-
01-21-2016, 04:13 PM #8
- Join Date
- Dec 2015
- Posts
- 50
Thanks for all the reply guys. I'd been going at it systematically for two weeks but ran out of ideas to be honest. Temp and flow rate seemed to help but I think they just masked the real issue. I will go back to the settings suggested above and let you guys know how it goes. Maybe from there you can give me a suggestion as to what to fix. I will recalibrate e-steps and check my z-offset again too.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help