Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 10

Threaded View

  1. 01-19-2016, 10:57 AM #1
    kd7eir
    kd7eir is offline
    Technologist
    Join Date
    Oct 2014
    Posts
    134

    Itty Bitty Double Flex nightmare

    I just installed the Itty Bitty Double Flex, flashed the firmware for it, did M502 followed by M500.
    All of my prints seem to have about ten times too much PLA extruded.

    I have attached a picture of the 2mm spacer that I printed before installing the Itty Bitty Double Flex, and one that I tried to print immediately after. I used the same GCode file in both prints.DSC_0009.jpg
    Last edited by kd7eir; 01-19-2016 at 11:03 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules