Tea time will never be the same now that a man who goes by the username "istimat" has posted his design for a 3D printed and Arduino-powered Lazy Man's Tea Steeper. Born from a bad tea brewing experience when the tea was over-brewed, leaving a bitter taste, this project to revolutionize the way we make tea was set into motion. The result was a device that waits for you to hang a tea bag on it once it's powered on. It then proceeds to dunk the bag three times, wait three minutes, and then lift the bag to let it drip: a perfect cup of tea every time! Read more and get the design file at http://3dprint.com/114996/3d-printed-tea-steeper/