Results 1 to 10 of 10
Threaded View
-
11-14-2015, 04:28 PM #4
This is driving me nuts. Got a nice first layer put down and I decided to let it run for a bit to see what happened, while I sat and watched it. First layer seemed like it was actually putting out a lot of filament. Then it goes to do the second layer and nothing. then it just ate a cresent out of the filament and decided not to feed anymore.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion