Results 1 to 7 of 7
Threaded View
-
11-14-2015, 03:44 PM #5
Hi,
I was about to say it could be residual ooze, but hearing in your video that the extruder is working...
Just out of curiosity, what speed have you set ? Try reducing to 30mm/s for starters.
Have you put in your slicer a height max (stop printing over this height) ?
Do you have an end code (like go to X0,Y0) ?
If the motors are hot and it is none of the above, it might be board or motor issue.
Please explain to me how to...
Yesterday, 03:08 PM in 3D Printer Parts, Filament & Materials