Quote Originally Posted by EagleSeven View Post
??? Don't the X & Y stepper-motors get Too Hot with those Enclosures ?
Mine got Way too hot without an enclosure, during long prints.
I had to install a fan there.

I've read about those motors Failing, caused by overheating,
and since they are too hot to touch, they are too hot to operate long.
The creator pro comes with the enclosures, and lots of people are using them without any problems. With the enclosure and the bed set to 110, it only gets up to about 40c which shouldn't hurt the motors.

I print abs on glass, I use abs juice applied before each print. The prints stick almost too well, I have to put the glass plate in the freezer before I even try to remove them.