MakerFarm Prusa i3v 10" - And So It Begins!

[tfast500]

Thanks guys I will give these tips and suggestions a go and report back.

Tonight I was able to mount the power supply and electronics. I routed my power wires around the back since I did not have enough room to go up through the channel in the bottom. Looks pretty good to me. I am happy with the cable management so far.

Tomorrow I should have everything hooked up and hopefully be able to test and calibrate the printer I am pretty excited to see this all come together and hopefully work!

I must admit this is taking way longer than I expected to put together. Partially do to taking my time with everything. Also breaking up the build into stages.

Pictures:

IMG_20150929_220827264_HDR.jpg IMG_20150929_220854045.jpg