Quote Originally Posted by drinu16 View Post
Hi, Sorry to bring up an old thread but couldn't find any other posts or information about this problem.

Have you reduced the wobble by any chance as I am having the same problem and it is effecting print quality. its only on one side of the print, where it wobbles the most.
I replaced bearings and rods and it did improve things to the point where I wasn't getting any more wobble/looseness.

What I found was that the old bearings were actually OK (or perhaps more standard), it was the rods that were undersized. I mic'd both the old and new rods, and the old rods were slightly smaller diameter. I probably could have gotten away with just replacing rods, but there was no way to tell in advance. But just because my rods were the issue doesn't mean that will follow for your problem (that is, assuming you can actually see a sloppy fit between your bearings and rods). As always, your mileage may vary.