Fixed FFCx but now prints have weird seam ?

[Entity]

Ok trying a print now,

Been so long, what feed and travel do you generally use for ABS.

I was running 70 & 80 previously but now with new motherboard etc have slowed it right down for this print to 40 & 70.
using the FFCx to experiment with settings before doing final prints in the new creator pro.

Thanks again for taking time out to reply.

[Entity]

Well,

Just tried a different print after changing extruder selection to hold, and didn't have the issue I had with that print earlier, so sshall try the print a posted image of tomorrow as its now 02:00.

Thanks again for the helpful advise.

Cheerss

[jfkansas]

My standard settings are 80 and 120. This is with one print head/stepper removed so that removes lots of weight.