Qidi Tech 1 - Replicator 1 clone

[rcleav]

I took mtnride's idea and made my own inserts to go at the bottom of the guide rods. Not sure if it makes a difference but I figured that it couldn't hurt. I can post it on Thingiverse but I'd prefer to get mtnride's OK before doing so since it was his idea.

20160312_203755.jpg

Again nice work I was thinking along the same lines just hadn't gotten around to modeling it yet. Since my CAD skills are still in the beginning stages I may have to borrow your design.
Also not sure if this is really a problem my CTC with arm stiffeners has more side to side then my Qidi and it's prints look just as good.