Qidi Tech 1 - Replicator 1 clone

[wirlybird]

How are you guys preventing color bleed when changing filaments? I changed from red to yellow but after several prints the yellow is still tinged with the red.

[wirlybird]

Here is an update on the monster dry box.

Getting the rails in.




The rails are in and the rollers in place. More rollers to make!




A front look at the 5 roll monster. It will be equipped with reusable desiccant packs and humidity indicator. There is also room for storage.

[DaveB]

Here is an update on the monster dry box.
Getting the rails in.
The rails are in and the rollers in place. More rollers to make!
A front look at the 5 roll monster. It will be equipped with reusable desiccant packs and humidity indicator. There is also room for storage.

That is looking sweet W! I did an axle in mine and I like your solution better. It makes swapping one roll out a huge amount easier.

[DaveB]

That is looking sweet W! I did an axle in mine and I like your solution better. It makes swapping one roll out a huge amount easier.

Reminds me of my old Corvair: rear engine then differential then transmission, all on a spline shaft thru the whole mess. Like some kind of unholy barbeque...