Quote Originally Posted by Arbitrary View Post
Makerbot. Turns out my issues was being on Replicator 2, not 1.

10mm cube results:

X - 10.22
Y - 10.19
Z - 10.24

Looks great to me. Right where I would expect it to be as far as margin of error goes.
That's about what I would get with my ReplicatorG/SkeinForge setup. Now I'm on Slic3r, and that's pretty much spot on in X and Y. I think it might be a little bit off in Z, but I haven't tested that yet. X and Y were easily tested on a print I did to test a snap fit design for my next project.