I have read a ton of debate on this subject on what is better. I am still on the fence.

My question is in regards to the filament as is is wrapped on the spool. Towards the end off a spool, my 3mm filament is almost impossible to use. It is tightly formed to the spool that it puts a lot of strain on the itself and will pull the spool out of my holder without actually unrolling.

I am using a bench spool holder and the filament rolls on bearings. I also have a bearing filament guide on the top of the printer where the old spool holder went.

Does 1.75 filment get this stiff towards the end of the roll?