Results 1 to 3 of 3
Thread: Lulzbot Taz 5 Filament Issue??
Threaded View
-
09-25-2015, 10:47 AM #1
- Join Date
- Jan 2015
- Posts
- 445
Lulzbot Taz 5 Filament Issue??
Good morning... So i finally got my taz going again after some filament jams due to peek heating.
Now im seeing a lot of burnt material in my prints, see below
I have the temp set at 195, which is fairly low compared to what i usually print at. Im also seeing a bit of over extrusion, so i may dial that back to .9 like S3Ds default. Perhaps that would help with the strining black stuff.
any other thoughts ?
thanks
Please explain to me how to...
Yesterday, 10:55 PM in 3D Printer Parts, Filament & Materials