Results 1 to 10 of 11
Threaded View
-
07-22-2015, 11:53 AM #7
the pin sockets are through hole mounted, so I just soldered 3 more pins worth of header to the butts on the other side facing out. Didn't explain very well but I just added pins onto what was there to pass the +V, G and signal straight through. This may be only applicable to the white one (sourced from makerfarm) so there could be differences, although I think this is like the RAMPS pretty consistent between mfgrs.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion