Ultimaker to Release an Overhaul of Cura Software Tomorrow

[Mjolinor]

Available to download for free from July 1, new Cura is set to take the 3D printing experience to a whole new level.

WRONG or are you hiding the Linux version somewhere else?

[nallath]

WRONG or are you hiding the Linux version somewhere else?

Should be online now.

[Mjolinor]

Should be online now.

64 bit only :bawling:

Talking of 64 bit I hope you fixed the popup on start up telling me there was an upgrade and then it trying to make me install the 64 bit on my 32 bit PC.

I don't think I am overly bothered really, it works really well as it is (15.02), my only complaint is not enough adjust-ability to things particularly the support and no % done commands for repg both of which I can work round or live without by adding support to my drawings.

Even the old ones leave all the other slicers I've tried for dead, so much so that I am considering buying an Ultimaker if I land on one cheap. Being from the Northern UK it is unlikely that I will find one that cheap anyway.