I was wondering (and apologize if it's been answered before) - Since it's essentially adaptable to various reservoir sizes, how big do you think you can get with the default assembly before it starts causing possible distortion or artifacts in the prints?

I would love to print raspberry pi cases or perhaps something like an iphone case for instance. Some of the smaller reservoirs I have seen so far appear to be a bit too small for these objects. So if I were to put a larger bin in, say, 10 inches in length, would this be acceptable for the printer? or would it cause issues?

I would love to see larger build platforms / slightly larger jar shapes or examples of something with a slightly larger base. I don't plan to print giant objects, but if it's something with a little lenght, I am curious how the peachy would fair.