Results 1 to 10 of 102
Thread: Itty Bitty Double FLEX Extruder
Threaded View
-
04-14-2015, 12:14 AM #11
- Join Date
- Mar 2015
- Location
- Palo Alto
- Posts
- 63
So after turning down the drivers the motors were basically room temp the entire 2 hours. DSC_6360-1-M.jpg
There was actually some skipping of the extruder motors only during infill. My infill speed (60mm/s) is not terribly faster than perimeters (50mm/s). May have to bump the current back up a bit (0.9A maybe). Thanks for all the help so far Clough42!
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion