Results 1 to 10 of 32
Thread: SgtToe 12" i3v Build Thread
Threaded View
-
04-12-2015, 12:34 AM #27
- Join Date
- Feb 2015
- Location
- Flagstaff, AZ
- Posts
- 73
Finished! There were a few dark specks that seemed to come out of the extruder but other than that I think this is a decent looking first print. All I did was level the table. I think I need to calibrate the extrusion rate next, any other ideas or recomendations? Is this quality good enough for me to print all the printable spare parts for the the I3v?
20150411_221336.jpg20150411_221418.jpg20150411_221317.jpg20150411_221510.jpg
Lastly I noticed this goober on the bottom of the extruder, is that normal?
20150411_221657.jpg
Oh and do I need to apply hairspray or glue stick before each print?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help