Results 1 to 10 of 12
Hybrid View
-
03-16-2015, 06:25 PM #1
- Join Date
- Oct 2014
- Posts
- 41
Did you get this resolved ?
I have the same extruder and found that the small fan wasn't up to the job so designed and printed off a fan duct to take a 40mm fan. i also had to reduce retract settings as this was also causing issues with this extruder.
-
03-16-2015, 11:13 PM #2
I only had one PLA filament. And since I was getting really good results with ABS, I had not pursued this again. But I now have a few sample PLA filaments on hand and I will need to revisit this.
This is in a PEI plate on the Taz5. I have had very little issue with warp with ABS. The only issue I have had to date was printing a 10" LED light strip that was not very tall (Z axis). It wanted to curl on the ends. I added extra pads on the corners and it printed just fine.
I am not saying I did things right. Just saying its been working.
I am willing to entertain suggestions as to what to change or improve. I would dearly love some constructive feedback as to procedures and settings.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials